- Frames
- >
- Crossbones 6-Inch FPV Quadcopter
Crossbones 6-Inch FPV Quadcopter
** SOLD OUT **
A frame designed by FPV racing and acro enthusiasts with versatility in component placement. Crossbones is a pod-like design with super low drag yet still allows a GoPro to be mounted. 6-Inch propellers optimize flight time without compromising weight and vibration. Our new QXC carbon fiber plates are constructed of the highest strength standard modulus fibers available - T700. These never-twisted carbon fibers are prepregged then bonded into a high strength armor plate. T700 fiber is used in a variety of industrial and recreational applications, including pressure vessels such as natural gas storage tanks and SCUBA breathing tanks. The multipurpose antenna mount made of tough flexible TPU accommodates VAS Minion, Luminier Axii, Axii stubby, or TBS Unify/SMA and mounts for standard RC "rabbit-ears" or a TBS Crossfire T-style antennae. You get a color coordinated set of standoffs, micro camera mount, and the multipurpose antenna mount.
|
|
|
- Made with our QXC Carbon Fiber
- Weight: 89g
- True X for 6" propellers, 236mm motor to motor
- 20mm short height keeping the Center of Gravity very close to the Center of Thrust
- Anodized aluminum standoffs with knarled texture
- Flex TPU mounts for antennae and micro FPV camera
- Optional Flex TPU GoPro Session and Hero mounts available.
- Motor mounting from 12 x 12mm through 19 x 19mm center-to-center
- All parts compatible with V1
- Fully independently removable arms (Isolated from Flight Stack)
- Embedded nuts allowing simple installation and removal with eight titanium alloy screws
- Ultra thin profile arms reduces prop drag at the thrust source (9.5mm wide)
- Stout 5.0mm arm thickness
- Battery options: Top and Bottom mount (Bottom mount allows 0 or 90 degree battery orientation).
- Optional Flex TPU Battery Sleeves available.
- Self-adhesive Neoprene foam tape battery pad
- Foam landing pads
- Crossbones sticker!
- AUW dry: 320g (without battery)
- QXC Carbon Fiber Plate with twill weave and matt finish
- Titanium alloy M3 core screws and M3 aluminum screws
- 20mm aluminum anadoized knarled standoffs
- Flex TPU mounts for antennae and micro FPV camera
- Nylon hardware for low profile FC/PDB stack
- 25cm Quadrysteria anti-slip Battery strap
- Self-adhesive Neoprene foam tape battery pad
- Four custom high density foam landing pads
- Exploded assembly view
- Matek F405-CTR AIO Flight Controller (integrated PDB and OSD)
- ESCs: BLHeli_S DSHOT capable 30 Amp
- Motors: 2205, 2206, 2306, 2207 near 2300KV with 4S LiPo, near 1600kv with 6S LiPo
- DALPROP T6040C Cyclone propellers
- XT60 battery pigtail
- Matek VTX-HV 25/200/500mW 5.8GHz Video Transmitter
- Runcam Micro Sparrow 2
- VAS Minion MMCX antenna (1pc)
- GoLo kit - Lower a V1 frame or change colors
- GoPro Hero mount made of flexible TPU
- GoPro Session mount made of flexible TPU
- Turtle Mode Fin made of flexible TPU - helps flip a down quad rightside-up
- Battery Protective Sleeve made of flexible TPU
- Backpack - Combined GoPro and Battery Sleeve made of flexible TPU